No products
MC-066-12/WSBK
New product
MWR developed in coorporation with profesional raceteams / MC Agusta RC the MC-066-12 / MC-066-12R / MC-066-12WSBK for the road & racebikes.
TIP: To maximize the ram-air effect ( and max. power) remove the protectiongauze at the front of the airtubes.
NOTE:Remapping the ECU or installation of a fuel devise is necessary.
MC-066-12 / MC-066-12R / MC-066-12WSBK INSTALLATION MC-066-12 / MC-066-12R / MC-066-12WSBK
Remove fuel tank to obtain access to the airbox ensure all pipes and leads are released before fully lifting the tank. The fuel pipe release is located on the left hand side behind the frame. The fuel pump lead is fitted directly into the fuel pump on the right side of the fuel tank base.
Remove all the retaining screws from the lid of the airbox please note the sensor on the left side has a serrated washer. Remove the air pressure sensor lead from the front of the airbox top and place it in a safe location.
Remove the original MV Agusta air filter, this can be achieved by simply cutting the filter into two parts if no longer required, alternatively remove the three bolt retaining the air tube to allow the original filter to be removed.
You are now ready to install the MWR air filter. You will see opposite the two air intakes two protruding flat vertical plates. The plates are to be used to secure the MWR filter into its correct design location with the dome to the rear of the air box (WSBK filter).
Place the MWR filter into the location pictured , ensure the location points on both sides of the filter and securely mounted into the two vertical plates by dropping it into position , the four bent hooks on the filter must hold the filter in place. You will see a lip on the base of the airbox ensure the filter is placed at the front to complete the fitment of the filter fully.
Once completed simply reverse the procedure.