Heinz Bike - Flasher relay

CAN-BUS resistor

Resistor with DIP-switch for vehicles equipped with a CAN-BUS system

The newly developed CAN-BUS resistor provides a required electrical load for your vehicle.
vehicle, which, when the dip switches are set correctly, means that there is no
no error message in the cockpit (rapid flashing of the indicator light in the dashboard).
indicator lamp in the dash).
In addition, there is a fail-safe feature. This means: In the event of failure of the accessory turn signals
failure due to an electronic defect, an error message is immediately displayed in the cockpit.

Up to 2 channels can be operated, e.g. rear left indicator and rear right indicator.
rear right.

The following resistance values can be set:

150 Ohm, 170 Ohm, 240 Ohm, 300 Ohm, 400 Ohm, 600 Ohm, 1200 Ohm.

Dimensions:
Height = 11mm, Width = 31mm / 46mm (with tabs), Length = 40mm.

Cable length = 200mm with pins

Connections:
Yellow = input channel 1 (+)
Orange = Output channel 1 (+)
Blue = Input channel 2 (+)
Red = Output channel 2 (+)
Grey = Input ground (-)
Black = Output ground (-)